Revision as of 07:15, 28 May 2011

If you wish to use any of these images in any way, you must place the following request for donation and PayPal button immediately adjacent to your use of the images:

An off-contract device purchased at full price by Rod Whitby was used in this tear-down. To recoup that cost, your PayPal donation is requested.

<paypal></paypal> Further pictures of the internals of the Veer (including 7MP high resolution shots of the circuit boards) will be added to this page as sufficient donations are received.

<paypal></paypal> I need $280 to replace this device with a developer device I can use to port and test homebrew applications and patches. The current donation total is $55

First, here is the rear of the device before disassembly starts. As you can see, it's an AT&T Veer. To be very clear, this is a device which was purchased at full price off-contract from an AT&T store. There are no strings attached to this device. It was not a free or discounted developer device. The device did not come from HP. There is no NDA, embargo, convenant, or other restriction on this device. Hence there are no qualms in dismantling it. So that we shall do now ...

Step 1: Initial keyboard separation

Separate the plastic around the bottom of the keyboard and the sides of the phone using your fingernail or a spudger.

Step 2: Initial lower half separation

Further separate the backplate at the bottom of the phone and along the sides, but do not pull it any further apart than this.

Note that the volume rocker switch is part of the backplate ...

... but the magnetic connector is not.

Step 3: Initial upper half separation

Now separate the plastic around the top of the phone, but do not pull it any further apart than this.

Step 4: Backplate separation achieved

The backplate is now fully separated, but do not take it further than this at this stage.

Step 5: Warranty sticker

Note the white warranty sticker between the backplate and the body of the phone. If this sticker separates from either the body or the backplate, your warranty is voided.

Step 6: Battery removal

It is possible to remove the battery without dislodging the white warranty sticker.

Teaser

Here's a taste of what you'll see when the donation total is reached ...

@@ Line 34: / Line 34: @@
 [[Image:Veer_05.jpg]]
+Note that the volume rocker switch is part of the backplate ...
 [[Image:Veer_06.jpg]]
+... but the magnetic connector is not.
 [[Image:Veer_07.jpg]]

Difference between revisions of "Veer Disassembly"