How to disassemble a HP Veer

Copyright Notice: All images on this page are copyright by Rod Whitby, with all rights reserved.

If you wish to use any of these images in any way, you must place the following request for donation and PayPal button immediately adjacent to your use of the images:

An off-contract device was purchased at full price by Rod Whitby for use in this tear-down. To recoup that cost, your PayPal donation is requested. <paypal></paypal>

Further pictures of the internals of the Veer (including high resolution shots of the circuit boards) will be added to this page as sufficient donations are received.

Start Here

Step 1: Initial keyboard separation

Separate the plastic around the bottom of the keyboard and the sides of the phone using your fingernail or a spudger.

Step 2: Initial lower half separation

Further separate the backplate at the bottom of the phone and along the sides, but do not pull it any further apart than this.

Step 3: Initial upper half separation

Now separate the plastic around the top of the phone, but do not pull it any further apart than this.

Step 4: Backplate separation achieved

The backplate is now fully separated, but do not take it further than this at this stage.

Step 5: Warranty sticker

Note the white warranty sticker between the backplate and the body of the phone. If this sticker separates from either the body or the backplate, your warranty is voided.